Net Port Power Can Hide Autotransformer Internal Current
Two incoming port powers can feed one outgoin…
記事の原文を読む資料技術情報
技術資料
変圧器用鉄心の選定、設計、製造に役立つ技術記事をまとめています。
1,317 件の記事
Autotransformer Fault Duty: Compare Single-Source Cases
A lower total fault current at a bus does not…
記事の原文を読むSeparate Conductive and Magnetic Zero-Sequence Paths in an Autotransformer
A shared conductive path changes the sequence…
記事の原文を読むModel Autotransformer Neutral Potential through the Actual Grounding Network
A common neutral connects more than one volta…
記事の原文を読むAutotransformer Series Voltage: Separate Section and Ground Duty
A relatively small voltage across the series …
記事の原文を読むConvert Autotransformer Impedance without Losing the Ohmic Value
A base change alters a per-unit number. It sh…
記事の原文を読むAutotransformer Tap Location: Derive the Connected Turns
A tap's physical proximity to neutral suggest…
記事の原文を読むEqual Tap Turns Can Produce Unequal Autotransformer Ratio Steps
When a tapped quantity appears in a ratio den…
記事の原文を読むAdd the Tertiary before Drawing the Autotransformer Load Boundary
A tertiary changes the ampere-turn balance. R…
記事の原文を読むAutotransformer Common-Winding Current: Use Signed Phasors
The common winding carries a branch-current d…
記事の原文を読むGive Different Shell-Form Coil Groups Different Thermal Nodes
One average winding node can reproduce total …
記事の原文を読むSeparate Autotransformer Through-Power from Winding Duty
Terminal MVA is not the same quantity as the …
記事の原文を読む該当する記事が見つかりませんでした。より一般的なキーワードで検索してください。
技術ノート
公開記事を補足する短い技術ノートです。