Lamination Alignment Is a Magnetic and Assembly Variable
An offset lamination is not just an untidy ed…
원문 읽기자료엔지니어링 자료
절단·적층·조립
변압기 철심 제조 공정의 절단, 적층, 조립을 다룬 기술 글을 모았습니다.
100 건
What Cutting Changes Near a GOES Edge
A sheared edge has two stories: the burr you …
원문 읽기More Step-Lap Steps Do Not Automatically Make a Better Core
Adding steps changes a joint design. It does …
원문 읽기One Joint-Gap Reading Cannot Represent a Whole Stack
The inspection sheet shows one joint-gap valu…
원문 읽기The Smallest Step-Lap Gap Is Not the Whole Objective
"Close the gap as much as possible" is not a …
원문 읽기Clamping Pressure Is Not a More-Is-Better Setting
The torque wrench clicks. The core is still n…
원문 읽기Mechanical Stress After the Core Is Built
The chemistry has not changed. The magnetic r…
원문 읽기A Supplier Audit Should Follow One Core Backwards
Skip the second tour of the cutting line. Cho…
원문 읽기Compare Transformer Core Quotes at the Same Handover Scope
A core quotation can win on USD per tonne and…
원문 읽기Premium GOES or Better Core Manufacturing Control?
Could an ordinary GOES grade outperform a pre…
원문 읽기Transformer Core Drawings and Manufacturing Recipe Control
Look at two cores made to the same drawing. T…
원문 읽기Same CRGO, Different Finished-Core Performance
Two cores can start with the same steel grade…
원문 읽기검색 조건에 맞는 글이 없습니다. 더 일반적인 키워드로 다시 검색해 주세요.
기술 노트
공개 기술 글의 내용을 보완하는 짧은 기술 노트입니다.