Lamination Alignment Is a Magnetic and Assembly Variable
An offset lamination is not just an untidy ed…
記事の原文を読む資料技術情報
切断・積層・組立
変圧器用鉄心の製造における切断、積層、組立の技術記事をまとめています。
100 件の記事
What Cutting Changes Near a GOES Edge
A sheared edge has two stories: the burr you …
記事の原文を読むMore Step-Lap Steps Do Not Automatically Make a Better Core
Adding steps changes a joint design. It does …
記事の原文を読むOne Joint-Gap Reading Cannot Represent a Whole Stack
The inspection sheet shows one joint-gap valu…
記事の原文を読むThe Smallest Step-Lap Gap Is Not the Whole Objective
"Close the gap as much as possible" is not a …
記事の原文を読むClamping Pressure Is Not a More-Is-Better Setting
The torque wrench clicks. The core is still n…
記事の原文を読むMechanical Stress After the Core Is Built
The chemistry has not changed. The magnetic r…
記事の原文を読むA Supplier Audit Should Follow One Core Backwards
Skip the second tour of the cutting line. Cho…
記事の原文を読むCompare Transformer Core Quotes at the Same Handover Scope
A core quotation can win on USD per tonne and…
記事の原文を読むPremium GOES or Better Core Manufacturing Control?
Could an ordinary GOES grade outperform a pre…
記事の原文を読むTransformer Core Drawings and Manufacturing Recipe Control
Look at two cores made to the same drawing. T…
記事の原文を読むSame CRGO, Different Finished-Core Performance
Two cores can start with the same steel grade…
記事の原文を読む該当する記事が見つかりませんでした。より一般的なキーワードで検索してください。
技術ノート
公開記事を補足する短い技術ノートです。