Lamination Alignment Is a Magnetic and Assembly Variable
An offset lamination is not just an untidy ed…
Ler artigo completoBIBLIOTECARecursos de engenharia
Corte, empilhamento e montagem
Artigos de engenharia aplicados à seleção, ao projeto e à produção de núcleos de transformadores.
100 artigos
What Cutting Changes Near a GOES Edge
A sheared edge has two stories: the burr you …
Ler artigo completoMore Step-Lap Steps Do Not Automatically Make a Better Core
Adding steps changes a joint design. It does …
Ler artigo completoOne Joint-Gap Reading Cannot Represent a Whole Stack
The inspection sheet shows one joint-gap valu…
Ler artigo completoThe Smallest Step-Lap Gap Is Not the Whole Objective
"Close the gap as much as possible" is not a …
Ler artigo completoClamping Pressure Is Not a More-Is-Better Setting
The torque wrench clicks. The core is still n…
Ler artigo completoMechanical Stress After the Core Is Built
The chemistry has not changed. The magnetic r…
Ler artigo completoA Supplier Audit Should Follow One Core Backwards
Skip the second tour of the cutting line. Cho…
Ler artigo completoCompare Transformer Core Quotes at the Same Handover Scope
A core quotation can win on USD per tonne and…
Ler artigo completoPremium GOES or Better Core Manufacturing Control?
Could an ordinary GOES grade outperform a pre…
Ler artigo completoTransformer Core Drawings and Manufacturing Recipe Control
Look at two cores made to the same drawing. T…
Ler artigo completoSame CRGO, Different Finished-Core Performance
Two cores can start with the same steel grade…
Ler artigo completoNenhum artigo encontrado. Tente uma palavra-chave mais abrangente.