Thin-Gauge GOES: The Handling Decision Behind the Loss Decision
The thinner sheet reaches the stacking statio…
Lire l’article completBIBLIOTHÈQUERessources techniques
Bibliothèque technique
Articles techniques pratiques sur la sélection, la conception et la fabrication des noyaux de transformateurs.
324 articles
Domain-Refined GOES: Protecting the Benefit After Delivery
A stress-relief operation can remove somethin…
Lire l’article completWhen Two Loss Results Are Not Comparable
Supplier A reports fewer watts than Supplier …
Lire l’article completAverage W/kg Can Hide a Local Problem
A core can have an acceptable average loss wh…
Lire l’article completA No-Load Loss Failure at Transformer FAT
FAT has found excessive no-load loss. The inv…
Lire l’article completWhat 90%, 100% and 110% Excitation Can Reveal
One excitation point gives you a result. Seve…
Lire l’article completHigh Measured Loss: Start with the Measurement Boundary
Before ordering a different CRGO grade, repea…
Lire l’article completNormal Loss, High Exciting Current: Where to Start
The watts are acceptable. The exciting curren…
Lire l’article completThe Magnetic Consequences of a Punched Hole
A hole is a missing piece of the magnetic pat…
Lire l’article completLamination Alignment Is a Magnetic and Assembly Variable
An offset lamination is not just an untidy ed…
Lire l’article completWhat Cutting Changes Near a GOES Edge
A sheared edge has two stories: the burr you …
Lire l’article completMore Step-Lap Steps Do Not Automatically Make a Better Core
Adding steps changes a joint design. It does …
Lire l’article completAucun article correspondant. Essayez un mot-clé plus général.
Fiches de référence techniques
Des fiches de référence synthétiques complètent les articles publiés dans leur intégralité.