Chenfan Electric
Tiếng Việt
Gửi bản vẽ
Quay lại Video kỹ thuật

Thư viện video kỹ thuật

Lamination Cleanliness and Interlaminar Short-Circuit Risk

Thời lượng 00:53 · 1080 × 1920

Tóm tắt kỹ thuật

Debris between core laminations can affect insulation, sheet spacing and pressure distribution. This video follows metallic chips and non-metallic contamination through packet building and stacking. It covers separation from cutting and grinding, clean handling, surface inspection and investigation of low core-to-clamp insulation readings.

Tải phụ đề

Bản chép lời
A clean-looking core can still hide something between its sheets. At the cutting line, remove chips and fines before forming packets. A conductive chip can bridge the coating. Contacts that close a loop linked by changing magnetic flux can allow current to circulate across sheets. Non-metallic debris can also hold sheets apart and make pressure uneven. Separate stacking from cutting and grinding. Wear clean gloves, keep tools and packaging off the stack, and inspect the surface before adding the next packet. After assembly, check core-to-clamp insulation resistance. If the reading is low, investigate the cause. The finished core's outside appearance is not a substitute for a clean build.

Yêu cầu về dự án

Liên hệ đội ngũ của chúng tôi ↗
Chenfan Electric

Trao đổi trực tiếp

Bắt đầu trao đổi.

Trao đổi về bản vẽ, nhu cầu vật liệu hoặc dự án.

Gửi bản vẽ